Sebring Sedan L4-2.4L VIN J (2004)
(a) One screw is located at lower rear screw pocket.
(b) Three screws located along the bottom of door.
(c) One screw located inside handle opening.
(d) One screw located at the upper front.
(e) One screw in the pull cup.
(8) Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points.
(9) Lift trim panel upward and away from door, disengage trim panel from upper retainer channel.
(10) Disengage clip attaching latch linkage to back door handle.
(11) Disconnect electrical connectors as necessary, including lower foot light, If equipped.
(12) Remove door trim panel from door.
INSTALLATION
(1) Position door trim panel near to door.
(2) Connect electrical connectors as necessary, including foot light, if so equipped.
(3) Engage clip attaching latch linkage to inside door handle.
(4) Lift the door trim slightly to get the lock knob into its bezel opening on the panel.
(5) Place front portion of upper trim strip flange into retainer channel, while seating white forward locator pin into mating bole in sheetmetal at
front of door.
(6) Drive screw into forward locator cup.
(7) With rear of panel slightly lifted, engage remainder of trim strip flange into retainer channel, working from front to back, pressing down firmly.
(8) Engage two hidden clips attaching rear of door trim to their mating (green) grommet holes in the door. Press the rear of the panel firmly in
toward the door, listening for engagement clicking sounds at BOTH of the clips.