Sebring Sedan L4-2.4L VIN J (2004)
Seat Track: Testing and Inspection
POWER SEAT TRACK
1. Remove power seat switch from seat.
2. Disconnect wire harness connector.
3. Check Pin 1 for battery voltage and Pin 5 for ground. On convertible models refer to step 5.
Switch Harness Connector Circuit Test
Seat Switch Electrical Connector - Hardtop
4. To test the seat motors, refer to the, and verify proper seat responses. Using two jumper wires, connect one to a battery supply and the second to a
ground. Connect the other ends to the seat wire harness connector as described in the Switch Harness Connector Circuit Test table.