Sebring Sedan L4-2.4L VIN J (2004)
3. Install outer CN joint assembly onto interconnecting shaft by using a soft-faced hammer and tapping end of stub axle (with nut installed) until
outer C/V joint is fully seated on interconnecting shaft (Fig. 41).
4. Outer C/V joint assembly must be installed on interconnecting shaft until cross of outer C/V joint assembly is seated against circlip on
interconnecting shaft (Fig. 42).
5. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
6. Install outer C/V joint sealing boot to interconnecting shaft clamp evenly on sealing boot.