Sebring Sedan L4-2.4L VIN J (2004)
7. Clamp sealing boot onto interconnecting shaft using crimper, Special Tool C-4975-A and the procedure. Place crimping tool C-4975-A over
bridge of clamp (Fig. 43). Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face (Fig. 44).
CAUTION: Seal must not be dimpled, stretched, or out-of-shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape it
by hand.
8. Position outer CN joint sealing boot into its retaining groove on outer C/V joint housing. Install sealing boot to outer CN joint retaining clamp
evenly on sealing boot.
