Town & Country V6-3.8L VIN L (2006)
A/C Condenser Right Hand View
4. Disconnect the A/C discharge line and the A/C liquid line from the right side of the A/C condenser.
5. Install plugs in, or tape over the opened discharge and liquid line fittings and the condenser ports.
6. Disengage the retaining clips that secure the upper A/C condenser mounting brackets to the radiator.
7. Lift the A/C condenser (combination cooler) straight up to disengage the lower mounting brackets from the radiator and carefully remove the
condenser from the engine compartment.
INSTALLATION
NOTE:
-
If the A/C condenser is being replaced, add 50 milliliters (1.7 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant oil of
the type recommended for the A/C compressor in the vehicle.
-
Be certain that each of the radiator and condenser air seals are reinstalled in their proper locations. These air seals are required for proper A/C and
engine cooling system operation.
1. Position the A/C condenser (combination cooler) into the engine compartment.
2. Carefully lower the A/C condenser straight down to engage the lower mounting brackets to the radiator.
3. Engage the upper A/C condenser mounting brackets to the radiator. Be sure that the upper retaining clips are fully engaged to the upper mounting
brackets.
4. Remove the tape or plugs from the opened refrigerant line fittings and the condenser ports.
5. Connect the A/C discharge line and the A/C liquid line to the A/C condenser.
6. Connect the transmission oil cooler lines to the quick-connect fittings located on the transmission cooler tapping block. Be sure that the
quick-connect fittings are fully engaged to the lines.
7. Install the front fascia.
8. Evacuate the refrigerant system.
9. Charge the refrigerant system.