Town & Country V6-3.8L VIN L (2006)
Evaporator Core: Service and Repair
Front A/C Evaporator
REMOVAL
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel Service and Repair
A/C Evaporator
1. Remove the front HVAC housing.
2. Disassemble the front HVAC housing as necessary to access the front A/C evaporator.
3. Open the rubber flange seal and carefully lift the front A/C evaporator and insulator out of the lower half of the front HVAC housing.
NOTE: If the insulator is deformed or damaged, it must be replaced.
4. If required, remove the insulator from the front A/C evaporator.
INSTALLATION
NOTE: If the front A/C evaporator is being replaced, add 50 milliliters (1.7 fluid ounces) of refrigerant oil to the refrigerant system. Use only
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
1. If removed, install the insulator over the front A/C evaporator.
NOTE: Make sure that the evaporator drain within the front HVAC housing is clean and unrestricted and that the insulator and the rubber flange
seal are properly positioned.
2. Install the front A/C evaporator into the lower half of the front HVAC housing and close the rubber flange seal.
3. Assemble the front HVAC housing.
4. Install the front HVAC housing.