Town & Country V6-3.8L VIN L (2006)
Evaporator Core: Service and Repair
Rear Evaporator
REMOVAL
1. Remove the rear HVAC housing and place it on a workbench.
Rear HVAC Air Doors
2. Disassemble the rear HVAC housing as necessary to access the rear A/C evaporator.
3. Carefully lift the rear A/C evaporator out of the inboard half of the rear HVAC housing and remove and discard the O-ring seals.
INSTALLATION
NOTE: If the rear A/C evaporator is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant
oil of the type recommended for the A/C compressor in the vehicle.
1. Position the rear A/C evaporator into the inboard half of the rear HVAC housing.
2. Lubricate new rubber O-ring seals with clean refrigerant oil and install them onto the evaporator tube fittings. Use only the specified O-rings as
they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
3. Assemble the rear HVAC housing.
4. Install the rear HVAC housing.