Town & Country V6-3.8L VIN L (2006)
17. Remove the heat shield from the steering gear.
18. Remove the two bolts and nuts mounting the steering gear to the front suspension cradle.
NOTE: The Delt step must be done to allow the removal of the steering gear from the front suspension cradle. The steering gear cannot be
removed from the vehicle with the intermediate coupler attached to the steering gear.
19. Lower steering gear from suspension cradle enough to allow access to the intermediate shaft coupler roll pin. Install Remover/Installer, Special
Tool 6831 A, through the center of the roll pin, securing with the knurled nut. Hold threaded rod stationary while turning nut, this will pull the roll
pin out of the intermediate shaft coupler.