Town & Country V6-3.8L VIN L (2006)
20. Separate the coupler from the steering gear shaft.
21. Remove the power steering gear from the vehicle.
INSTALLATION
STEERING GEAR - RHD
1. Install the steering gear up in the front suspension cradle crossmember, leaving room to install intermediate coupler.
2. Start the roll pin into the intermediate shaat coupler before installing coupler on steering gear shaft. Start roll pin into coupler, using a harrLmer
and tapping it into the coupler. Then install the intermediate shaft coupler on the shaft of the steering gear.
3. Install Remover/Installer Special Tool 6831A through the center of the roll pin, securing it with the knurled nut. Hold threaded rod stationary
while turning nut, pulling the roll pin into the intermediate shaft coupler.