Town & Country V6-3.8L VIN L (2006)
>
If the wiper motor label is white, continue to Step 3f.
>
If the wiper motor label is yellow, continue to Step 4.
f.
Remove the wedge and close the hood.
g.
Install and tighten the two center cowl grill screws and return the vehicle to the customer. No further action is required.
4.
Remove the wedge and lower the hood.
5.
Remove each front windshield wiper arm as follows:
a.
Using a wax pencil, mark the park location of the wiper blades onto the windshield.
b.
Remove the wiper arm protective cap.
c.
Remove the nut holding the wiper arm to the wiper pivot shaft.
d.
Using a suitable two jaw puller (such as a battery terminal puller), separate the wiper arm from the wiper pivot shaft.
e.
Repeat Steps 5a through 5d for the other wiper arm.
6.
Remove the two remaining screws securing the cowl cover to the wiper module.
7.
Disengage the two quarter turn fasteners located near the wiper pivot shafts of the cowl grill from the body. Note the initial position of the arrow
on the fastener is toward the windshield (Figure 3).
8.
Open the hood.
9.
Tape both rear corners of the hood and the fender edge by the cowl grill with masking tape or equivalent to prevent scratch damage to the cowl
grill and paint during removal.