Town & Country Van AWD V6-201 3.3L VIN R FI (1991)
Sliding Door Handle: Adjustments
Inside Release Handle Adjuster
1. Remove sliding door trim panel.
2. Release sliding door latch and slide the door open about 100 mm (4 in.).
3. Loosen socket head screw holding linkage bell crank together.
4. Using a screw driver through the elongated slot behind inside door handle, push linkage rearward to take up all free travel.
5. Tighten socket head screw to hold bell crank together.
6. Test inside door handle operation.
7. Install door trim panel.