daewoo Workshop Repair Guides

Daewoo Workshop Service and Repair Manuals

Inside Rearview Mirror|Page 4130 > < Inside Rearview Mirror|Page 4127
Page 1
background image

Mirrors: Service and Repair
Inside Rearview Mirror

The inside rearview mirror is attached to a support which is secured to the windshield glass. The support is installed by the glass supplier using a
plastic-polyvinyl butyl adhesive.

Service replacement windshield glass has the mirror support bonded to the glass assembly. In order to install a detached mirror support or install a new
part, the following items will be needed:

-

Loctite (R) Minute-Bond Adhesive.

-

Original or replacement mirror support.

-

Wax marking pencil or crayon.

-

Rubbing alcohol.

-

Clean paper towel.

-

Fine grit sandpaper (grit # 320 or # 360).

-

2 mm allen wrench.

Installation Procedure

1. Measure the distance from the headliner to the bottom of where the mirror support will be mounted on the windshield.

2. Mark this position on the outside of the glass with a wax pencil or crayon. Draw a large diameter circle on the outside of the glass around the

mirror support location.

3. Clean the inside surface of the glass with paper towels and a domestic scouring cleanser, a glass cleaning solution, or a polishing compound. Rub

the glass until the area is completely dry When the area is dry, clean the area with an alcohol-saturated paper towel in order to remove any traces
of scouring powder or glass cleaning solution.

4. If the mirror support is new, clean the bonding surface with fine grit sandpaper # 320 or # 360. If the original mirror support is being used, all

traces of factory-installed adhesive must be removed prior to reinstallation.

5. Wipe the sanded mirror support with a clean paper towel saturated with rubbing alcohol. Allow the support to dry.
6. Follow the adhesive kit manufacturer's directions for adhesive application and mirror support preparation before installing the mirror support to

the glass.

7. Position the mirror support to its premarked position. Use steady pressure and press the support against the glass for 30 to 60 seconds.
8. After 5 minutes, remove the excess adhesive with an alcohol-moistened towel or a glass cleaning solution.

Inside Rearview Mirror|Page 4130 > < Inside Rearview Mirror|Page 4127