Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
3. Position the brake pedal on the pedal-to-dash panel bracket and the pedal shaft.
4. Place the nut on the pedal mounting shaft.
Tighten
Tighten the brake pedal-to-pedal bracket nut to 18 Nm (13 ft. lbs.).
5. Install the pushrod to the pedal with the pin and the retaining ring.
6. Install the spring on the shaft in its original position.
7. Connect the stoplamp switch and the connector assembly by twisting it into the pedal bracket.
8. Install the trim panel with the screws.
Tighten
Tighten the trim panel screws to 7 Nm (62 inch lbs.).
