Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Brake Drum: Service and Repair
One-Piece Drum
Removal Procedure
1. Raise and suitably support the vehicle.
2. Remove the wheel.
3. Remove the split pin and the castle nut that secures the drum to the spindle. Discard the split pin.
4. Remove the rear brake drum.
Installation Procedure
1. Inspect the hub bearing, and coat it with grease, if needed.
2. Install the rear brake drum.
3. Secure the drum with the castle nut and the new split pin.
Tighten
Tighten the one-piece drum castle nut to 20 Nm (15 ft. lbs.) minus 180 degrees plus 1 Nm (9 inch lbs.).
4. Install the wheel.
5. Lower the vehicle.
