Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
5. Install the intake manifold support bracket upper bolts to the intake manifold.
Tighten the intake manifold support bracket upper bolts to 25 Nm (18 ft. lbs.).
6. Install the intake manifold support bracket lower bolt-to-engine block.
Tighten the intake manifold support bracket lower bolt-to-engine block to 40 Nm (30 ft. lbs.).
7. Install the generator. Refer to Starting and Charging.
8. Install the fuel rail and fuel injectors as an assembly. Refer to Powertrain Management.
9. Install the throttle cable bracket.
10. Install the throttle cable bracket bolts.
Tighten the throttle cable bracket bolts to 8 Nm (71 inch lbs.).
11. Connect the throttle cable to the intake manifold and the throttle body
12. Connect all of the necessary vacuum lines that were previously disconnected.
13. Connect the heater inlet hose to the cylinder head.
14. Connect the surge tank coolant hose to the throttle body.
15. Connect the CTS connector.
16. Connect the ECT sensor connector.
