Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Compressor Clutch Bearing: Service and Repair
Tools Required
J-6083 Snap Ring Pliers
J-8092 Driver Handle
J-8433-1 Puller Crossbar
J-8433-3 Forcing Screw
J-9398-A Bearing Remover
J-9481 Bearing Installer
J-33017 Pulley Rotor and Bearing Assembly Installer
J-33019 Bearing Staking Tool Set
Includes: J-33019-1 Bearing Staking Guide
J-33019-2 Bearing Staking Pin
J-33020 Pulley Puller
J-33023-A Puller Pilot
J-34992 Compressor Holding Fixture
J-42428 Compressor Holding Fixture
Disassembly Procedure
1. Disconnect the negative battery cable.
2. Recover the refrigerant.
3. Remove the compressor.
4. Remove the clutch drive plate and the hub assembly.
5. Remove the pulley rotor and the bearing assembly retaining ring using the snap ring pliers J-6083.
6. install the pulley puller J-33020 into the inner circle of slots in the pulley rotor. Turn the pulley puller J-33020 clockwise in the slots to engage the
puller tangs with the segments between the slots in the rotor.
7. Hold the pulley puller J-33020 in place and tighten the puller bolt against the compressor shaft to remove the pulley rotor and the bearing