Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Remove the hub and drive plate remover/installer J-33013-B. Check for proper positioning of the clutch hub key. It should be even or slightly
above the clutch hub.
9. Install the shaft nut. Hold the clutch drive plate and hub assembly with the clutch hub holding tool J-33027. Use the shaft nut socket J-33022 to
tighten the nut against the compressor shaft shoulder.
Tighten
Tighten the clutch plate and hub assembly nut to 17 Nm (13 lb.ft).
10. Spin the pulley rotor by hand to verify that the pulley is not rubbing the clutch drive plate.
11. Remove the compressor from the bend vise and remove the J-42428 compressor holding fixture from the compressor.
12. Install the compressor.