Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Place the rack guide assembly into the rod and rack assembly. Center the rack guide assembly in the housing window opening.
9. Slide a new boot clamp onto the rack and pinion boot.
NOTICE: Be sure centering cover washers are in place on rack and pinion boot. For ease of assembly, install the inner tie rod bolts through the
center cover washers and rack guide, then lightly thread the bolt into the rod and rack assembly. This will help keep the components in proper
alignment.
10. Position the boot clamps onto the rack and pinion boot. Crimp the clamp using the installer KM-J-22610. Be sure the boot retaining bushing is in
place.
11. Install the rack and pinion assembly into the vehicle.
Rack and Pinion Boot Disassembly and Reassembly-Power
RACK AND PINION BOOT
-
Tools Required
-
KM-J-22610 Installer
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.
2. Disconnect the hydraulic cylinder lines.
3. Cut off the rack and pinion boot clamps. Remove the mounting bracket bushing, the boot retaining bushing and the rack and pinion boot.
4. Replace the boot retaining bushing if it is damaged.
Assembly Procedure
