Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
2. Press the rear bushing onto the shaft. The flat of the bushing must be on the top side, the same as the ball joint. Use the remover/installer
KM-508-A to support the control arm.
3. Coat the outside of the front bushing and the inside of the lower control arm with a multipurpose lubricant.
4. Press the new bushing into the control arm from the back to the front, using the remover/installer KM-508-A.
5. Center the bushing.
6. Install the control arm.