Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Control Arm Bushing: Service and Repair
Rear
CONTROL ARM BUSHINGS
-
Tools Required
-
KM-266-A Remover
-
J-21474-18 Nut
-
J-21474-19 Puller Bolt/Thrust Washer
-
J-29376-A Control Arm Bushing Housing
-
J-29376-6A Rear Control Arm Bushing Remover/Installer
-
J-29376-7 Rear Control Arm Bushing Plate
Disassembly Procedure
1. Raise and suitably support the vehicle.
2. Remove the rear axle and secure it to a workbench. See: Axle Beam
NOTICE: To facilitate removal of damping bushings, warm the rear axle in the area of the bushings to approximately 50 to 75°C (122 to 158°F)
using an industrial hot air dryer.
3. Place the control arm bushing housing J-29376-A on the rear axle. Slide the puller bolt/thrust washer J-21474-19 through the control arm bushing
remover/installer J-29376-6A, the rear control arm bushing, the control arm bushing plate J-29376-7 and into the nut J-21474-18.
4. Partially remove the rear axle bushing by turning the nut J-21474-18 and counterholding the puller bolt J-21474-19.
5. Remove the rear axle bushing completely by striking the control arm bushing remover/installer J29376-6A with the remover KM-266-A.
Assembly Procedure