Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Heated Glass Element: Service and Repair
Rear Window Defogger Grid Line Repair
1. Disconnect the negative battery cable.
2. Disconnect the rear window defogger electrical connectors (left side electrical connector shown, right side electrical connector similar).
3. Inspect the rear window defogger grid lines.
4. Mark the grid line break on the outside of the glass with a wax pencil or a crayon.
5. Use steel wool to buff the grid lines that are to be repaired. Wipe the lines clean using a cloth dampened with alcohol. Buff and clean about 6 mm
(0.25 inch) beyond each side of the break in the grid line.
6. Attach a grid line repair decal or two strips of tape above and below the repair areas.
-
A repair decal or tape must be used in order to control the width of the repair areas.
-
If a decal is used, the die-cut metered slot must be the same width as the grid line.
7. Apply the grid repair material to the repair area using a small wooden stick or a spatula. The grid repair material should be at room temperature.
8. Carefully remove the decal or the tape.
