Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
NOTE: The grid line repair material must be cured with heat. In order to avoid heat damage to the interior trim, protect the trim near the repair
area where heat will be applied.
9. Heat the repair area for 1 to 2 minutes.
10. Hold the heat gun nozzle 25 mm (1 inch) from the surface. A minimum temperature of 149 °C (300 °F) is required.
11. Inspect the grid line repair area. If the repair appears discolored, apply a coating of tincture of iodine to the area using a pipe cleaner or a line
brush. Allow the iodine to dry for about 30 seconds. Carefully wipe off the excess iodine with a lint-free cloth.
12. Connect the rear window defogger electrical connectors.
13. Test the operation of the rear window defogger in order to verify that the repair was successful.
IMPORTANT: At least 24 hours is required for complete curing of the repair materials. The repair area should not be physically disturbed until
after that time.
