Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
3. Disconnect the front brake line(s) at the master cylinder.
4. Allow the brake fluid to fill the master cylinder until it begins to flow from the front pipe connector port.
5. Connect the front brake line(s) to the master cylinder.
-
Tighten the brake lines to 16 Nm (12 ft. lbs.).
6. Slowly push and hold the brake pedal one time.
7. Loosen the front brake line at the master cylinder to purge all air from the cylinder.
8. Tighten the brake line as in Step 5, and then release the brake pedal slowly. Wait 15 seconds before proceeding to the next step.
9. Repeat the sequence, including the 1 5-second wait, until all the air is removed from the master cylinder bore.
