Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
11. Remove the discharge hose.
INSTALLATION PROCEDURE
1. Install a new O-ring on the tube end that connects to the evaporator flange.
2. Position the hose assembly and the support clamp in the vehicle.
3. Insert the suction hose tube end into the evaporator flange.
4. Install the suction hose connector block retaining nut.
Tighten
Tighten the suction hose connector block retaining nut to 12 N.m (106 lb-in).
5. Install the suction hose support clamp bolt and tighten.
Tighten
Tighten the suction hose support clamp bolt to 4 N.m (35 lb-in).
6. Install new sealing washers onto the pilots of the suction/discharge block fitting. The washers must be seated against the surface of the block
fitting.
7. Position the discharge hose assembly with the A/C hose connector block.
