Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
2. With the rack gear centered' mark the location of the stub shaft notch on the housing to aid in the proper installation of the pinion and valve
assembly.
3. Remove the pinion shaft seal by pressing down on one side of the seal and pulling up on the other side of the seal.
4. Remove the retaining ring and pull the pinion and valve assembly out of the rack and pinion housing.
Assembly Procedure
Important: All the interlocking metal parts must be lubricated with lithium-base grease 1051344 or equivalent as they are assembled.
Important: When the pinion and valve assembly is fully seated in the housing, be sure the notch in the stub shaft and the mark on the housing line up.
Be sure the rack guide assembly is centered in the housing window.
1. Center the rack guide assembly in the housing window opening.
2. Line up the stub shaft notch with the mark on the housing. Seat the pinion and valve assembly into the rack and pinion housing.
3. Install the retaining ring and seat the pinion seal. The top of the seal should be flush with the top of the housing.
Disassembly and Reassembly Rack