Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
4. Install the timing belt idler pulley nuts.
Tighten
Tighten the timing belt idler pulley nuts to 25 Nm (18 ft. lbs.).
5. Increase the tension on the timing belt by turning the timing belt automatic tensioner hex-key tab counterclockwise until the pointer is aligned to
the indicator.
Tighten
Tighten the timing belt automatic tensioner bolt to 25 Nm (18 ft. lbs.).
6. Install the front timing belt cover.
7. Install the front timing belt cover bolts.
Tighten
Tighten the front timing belt cover bolts to 6 Nm (53 inch lbs.).
8. Install the engine mount bracket and retaining bolts.
Tighten
Tighten the engine mount bolts to 60 Nm (44 ft. lbs.).
9. Remove the engine support fixture J-28467-B.
10. Install the serpentine accessory drive belt. Refer to Steering; Power Steering Pump.
11. Install the air filter housing assembly with the bolts.
Tighten
Tighten the air filter housing bolts to 8 Nm (71 inch lbs.).
12. Install the right front wheel well splash shield.
13. Connect the negative battery cable.
