Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
9. Disconnect the six brake pipes from the hydraulic modulator.
9.1 Plug the brake pipes to prevent loss or contamination of brake fluid.
10. Remove the bolt at the front of the base of the hydraulic modulator/motor pack assembly.
11. Remove the hydraulic modulator/motor pack assembly from the vehicle.
12. Rotate the front end of the hydraulic modulator/motor pack assembly toward the engine while pulling the back end away from the fire wall to get
the mounting foot out from under the loop in its mounting bracket.
Installation Procedure
1. Install the hydraulic modulator/motor pack assembly to the vehicle.
Tighten
Tighten the hydraulic modulator/motor pack assembly bolt to 5.4 Nm (48 inch lbs.).
2. Remove the plugs from the brake pipes and connect them to the hydraulic modulator. Secure each pipe with a pipe nut.
Tighten
Tighten the brake pipe nuts to 15 Nm (11 ft. lbs.).
