Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
3. Install the motor pack and solenoid electrical connectors.
Important: Make sure the solenoid electrical connectors are correctly installed. The white connector goes to the solenoid at the front end of the
hydraulic modulator and the black connector goes to the solenoid toward the fire wall.
4. Replace the surge tank in its mounting and secure it with the bolt.
Tighten
Tighten the surge tank mounting bolt to 8 Nm (71 inch lbs.).
5. Connect the negative battery cable.
6. Bleed the brake system. See: Brake Bleeding
7. Check the engine coolant level (ECL), add a 50-50 mixture of antifreeze and water, if necessary.
Disassembly and Reassembly
Disassembly Procedure
1. Remove the hydraulic modulator/motor pack assembly from the vehicle.
