Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
the mounting foot out from under the loop in its mounting bracket.
Installation Procedure
1. Install the hydraulic modulator/motor pack assembly to the vehicle.
Tighten
Tighten the hydraulic modulator/motor pack assembly bolt to 5.4 Nm (48 inch lbs.).
2. Remove the plugs from the brake pipes and connect them to the hydraulic modulator. Secure each pipe with a pipe nut.
Tighten
Tighten the brake pipe nuts to 15 Nm (11 ft. lbs.).
3. Install the motor pack and solenoid electrical connectors.
Important: Make sure the solenoid electrical connectors are correctly installed. The white connector goes to the solenoid at the front end of the
hydraulic modulator and the black connector goes to the solenoid toward the fire wall.
