Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
4. Replace the surge tank in its mounting and secure it with the bolt.
Tighten
Tighten the surge tank mounting bolt to 8 Nm (71 inch lbs.).
5. Connect the negative battery cable.
6. Bleed the brake system. See: Brake Bleeding
7. Check the engine coolant level (ECL), add a 50-50 mixture of antifreeze and water, if necessary.
Disassembly and Reassembly
Disassembly Procedure
1. Remove the hydraulic modulator/motor pack assembly from the vehicle.
2. Remove the two solenoids from the hydraulic modulator/motor pack assembly.
3. Remove the gear cover from the hydraulic modulator/ motor pack assembly.
4. Remove the motor pack from the hydraulic modulator.
Important: No repair of the hydraulic modulator is authorized. Replace the modulator as an assembly.
Assembly Procedure
1. Install the motor pack onto the hydraulic modulator aligning the motor pack gears with the modulator gears.
2. Install the gear cover to the hydraulic modulator/motor pack assembly.
3. Install the solenoids onto the hydraulic modulator/motor pack assembly.
