Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Installation Procedure
1. Install the exhaust manifold gasket.
2. Install the exhaust manifold.
3. Install the exhaust manifold retaining nuts and tighten in the sequence shown.
Tighten the exhaust manifold retaining nuts 15 Nm (11 ft. lbs.).
4. Install the auxiliary catalytic converter upper flange nuts to the exhaust manifold.
Tighten the auxiliary catalytic converter-to-exhaust manifold nuts to 40 Nm (30 ft. lbs.).
5. Install the exhaust manifold heat shield.
6. Install the exhaust manifold heat shield bolts.
Tighten the exhaust manifold heat shield bolts to 8 Nm (71 inch lbs.).
7. Connect the pre-converter oxygen sensor connector.