Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
1. Connect the vacuum hose connection block to the mode control switch.
2. Press the cable end eyelet onto the post on the controller.
3. Attach the mechanical cable housing to its original control position.
4. Connect the electrical connectors to the sockets on the back of the controller.
5. Gently insert the controller into position on the center console.
6. Install the retaining screws.
Tighten
Tighten the HVAC controller retaining screws to 2 Nm (18 lb.in).
7. Connect the negative battery cable.
8. Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.
9. Install the audio system trim plate.
