Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Important: If the master cylinder is known or suspected to have air in the bore, it must be bled before any wheel cylinder or caliper is bled. If the
decision is made not to bleed the master cylinder, go to step 11.
2. Fill the master cylinder reservoir with brake fluid. Keep the master cylinder at least one-half full of fluid during the bleeding operation.
3. Disconnect the front brake line(s) at the master cylinder.
4. Allow the brake fluid to fill the master cylinder until it begins to flow from the front pipe connector port.
5. Connect the front brake line(s) to the master cylinder.
Tighten
Tighten the brake lines to 16 Nm (12 ft. lbs.).
6. Slowly push and hold the brake pedal one time.