Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
7. Loosen the front brake line at the master cylinder to purge air from the cylinder.
8. Tighten the brake line (as in step 5), and release the brake pedal slowly. Wait 15 seconds before proceeding to the next step.
9. Repeat the sequence, including the 15-second wait, until all the air is removed from the master cylinder bore.
NOTICE: Care must be taken to prevent brake fluid from contacting any painted surface to prevent damage to the paint finish.
10. After all the air has been removed at the forward connection(s), bleed the master cylinder at the rear (cowl) connection(s) in the same manner as
with the front connections.
Important: For vehicles without the antilock braking system (ABS), the bleeding sequence is as follows: right rear, left front, left rear and right
front. For vehicles with ABS, refer to Models With ABS Only for the correct sequence and bleeding procedure.
