Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
10. Disconnect the front wheel speed sensor electrical connector.
11. Remove the jumper harness clamp on the strut and pull the jumper harness through the body.
Installation Procedure
1. Install the front wheel speed sensor jumper harness. Route the harness through the body and secure the clamp on the strut.
2. Connect the front wheel speed sensor electrical connector.
3. Replace the wheel.
4. Lower the vehicle.
5. Replace the jumper harness into the wiring harness and route it through the fire wall into the vehicle interior at the EBCM.
