Removal and Installation of Alternator for Nubira SX Hatchback
10. Install the outside cover.
11. Position the rotor assembly shaft with the drive end frame in the slip ring end assembly until the gap between the outer race and the end frame
casting is 1.9 mm (0.075 inch).
12. Install the generator through-bolts.
Tighten
Tighten the generator through-bolts to 10 Nm (89 lb.in).
13. Position the fan, the collars, and the pulley on the rotor shaft and secure with the nut.
Tighten
Tighten the generator drive end bearing nut to 81 Nm (60 lb.ft).
14. Install the generator. Refer to "Generator".
