Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Front Steering Knuckle: Service and Repair
Removal and Installation
KNUCKLE ASSEMBLY
Tools Required
KM-507-B Ball Joint Remover
Removal Procedure
1. Raise and suitably support the vehicle.
2. Remove the wheel.
3. Remove the caulking nut from the axle shaft.
4. Remove the brake caliper from the rotor. Support the caliper so it does not hang from the hydraulic brake hose.
5. Remove the brake line from the knuckle.
6. Remove the outer tie rod from the knuckle assembly.
7. On vehicles equipped with the antilock braking system (ABS), disconnect the ABS speed sensor electrical connection from the knuckle.
