Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
8. Remove the ball joint pinch bolt and the nut.
9. Separate the knuckle from the ball joint using the ball joint remover KM-507-B.
10. Remove the nuts from the bolts that connect the knuckle assembly to the strut assembly.
NOTICE: Do not over extend the axle joints. When either end of the shaft is disconnected, overextension of the joint can result in separation of
internal components and possible joint failure. Use drive axle joint seal protectors whenever performing service on or near the drive axles. Failure
to do so can cause internal joint or seal damage and result in possible joint failure.
