Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
16. Remove the bolt from the rear hole of the upper bracket link.
17. Loosen, but do not remove, the bolt at the front of the upper bracket link.
18. Swing the upper bracket link to a vertical position to remove the pump easier.
19. Remove the upper bolt from the pump bracket.
20. Remove the pump.
Installation Procedure
1. Lower the pump into the vehicle, to a point just below its final mounting position.
2. Install the thermostat housing.
3. Install the pump to the pump bracket.