Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
5. Install the cylinder end dust boot retaining clamps with the installer KM-J-22610.
6. Install the tie rod end boot retaining clamps.
7. Reposition the adjusting nut to the marks on the inner tie rod and install the outer tie rod by twisting it onto the inner tie rod.
8. Perform a front toe adjustment.
9. Tighten the adjusting nut.
Tighten
Tighten the outer tie rod adjusting nut to 22 Nm (16 ft. lbs.)
10. Install the rack bearing assembly into the rack and pinion steering assembly.
11. Install the valve and pinion assembly into the rack and pinion steering assembly.
12. Install the rack and pinion steering assembly into the vehicle.
STUB SHAFT SEALS AND UPPER AND LOWER BEARING
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.