Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
1. Install the rack, the bulkhead inner cylinder and the bulkhead inner cylinder retaining ring.
NOTICE: To prevent the inner tie rods from loosening, use Loctite 242 (or equivalent) on both inner tie rod connections to secure them to the
rack shaft.
IMPORTANT: The right and left inner tie rods are unequal in length. Be sure to install the correct inner tie rod on the proper side of the power
steering gear.
2. Firmly seat the inner tie rods against the rack and tighten both ends simultaneously.
Tighten
Tighten the inner tie rods to 100 Nm (74 ft. lbs.).
3. Push the plastic retainer back onto the connection between the inner tie rod and the power steering gear rack.
4. Install the dust boot.
