3500 4x4 Pickup V10-488 8.0L Magnum (1994)
8.
Weld the new coil spring tower into position applying the welds as shown in Figure 11.
NOTE:
Refer to the Welding Procedure Specification Chart (flat, overhead, vertical up or down) to determine the correct direction that welding must be
performed (vertical/flat, up or down).
9.
Continue with Section "D - Install Front Suspension Coil Spring Tower Reinforcement Brackets."
D. Install Front Suspension Coil Spring Tower
NOTE:
All trucks require installation of both coil spring tower reinforcement brackets (even if the shock tower(s) was replaced).
IMPORTANT:
All welding must be performed by a qualified welder.