B250 3/4 Ton Van V8-318 5.2L VIN T FI (1992)
5.
Using the template provided in Figure 1, drill two 5/16" holes in the tail pipe hanger bracket.
6.
Position the new tailpipe hanger bracket in the same location that the old one was removed. Position the bracket so that the isolator mounting holes
are aligned fore and aft on the vehicle with the weld nut facing forward. Center punch and drill two 9/32" holes at the bracket hole locations.
7.
Install the tailpipe bracket using the two bolts listed above and tighten the bolts to 120 In.Lbs.
8.
Install the muffler bracket and isolator. Be sure to use the isolating pad that was located under the original bracket.
9.
Install the tailpipe assembly and install the new tailpipe isolator.
10.
Apply a coating of rust proofing to the entire length of the rear brake line from the flex hose to the union to prevent the shield from vibrating
against the line (See Figure 2).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
11-40-10-95
0.9 Hrs.
