Caliber L4-2.4L (2009)
Trunk / Liftgate Striker: Service and Repair
Striker - Installation
INSTALLATION
1. Position the liftgate striker (1) onto the liftgate opening lower panel and align the striker to the previously marked location.
2. Install the two bolts (4) that secure the striker to the lower panel. Tighten the bolts to 23 Nm (17 ft. lbs.).
3. Verify liftgate alignment and latch operation. The liftgate should fit flush and have even gaps to adjacent body panels. Gap specifications are as
follows:
-
7 mm (0.280 in.) to the fascia.
-
6 mm (0.240 in.) to the roof header.
-
4 mm (0.160 in.) to the body side.
4. Install the liftgate sill scuff plate See: Interior Moulding / Trim/Scuff Plate/Service and Repair/Scuff Plate - Installation.
