Caliber L4-2.4L (2009)
f.
When complete, select "Finish".
14.
Place the Ignition in the "OFF" position, then Power "Off" the StarMOBILE.
15.
Disconnect the Data Link Connector (DLC), wait 15 seconds, and reconnect the DLC to the vehicle.
16.
Place the ignition in the "RUN" position, power "ON" the StarMOBILE and restart the Desktop Client.
17.
Vehicles equipped with a four-speed transaxle, perform Transmission Control Module (TCM) Quicklearn programming using the following
procedure:
a.
From the "Home" screen, select "ECU View".
b.
Select "TCM Transmission Control Module".
c.
Select "Misc. Functions".
d.
Select "Quicklearn" and press the "Start" button on the Desktop Client.
e.
Follow the on screen instructions.
f.
When complete, select "Finish".
18.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the PCM programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Home" screen select "System View".
b.
Select "All DTCs".
c.
Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
d.
Follow the on screen instructions.
19.
Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE cable, and battery charger from the vehicle.
