Caravan AWD V6-201 3.3L (1991)
A/C Evaporator
26. Remove A/C evaporator coil out of unit.
27. Disconnect actuator linkage from fresh/recirculation door and vacuum lines from actuator. Loosen two nuts attaching actuator to housing and
remove actuator.
28. Remove four screws attaching fresh/recirculation cover to unit and lift off cover.
29. Fresh/recirculating door may now be removed from its housing.
30. To remove heat defrost door, remove retaining clip from shaft inside the housing. Pull shaft from housing and remove door.
31. To remove mode door, remove retaining clip from shaft inside the housing. Pull the shaft from the housing and remove door.
ASSEMBLY
1. Place evaporator coil into unit.
2. Place heater core into unit and fasten with screws.
3. Reinstall blower wheel onto blower motor shaft and secure with retaining clamp.
4. Feed blower motor wires through hole in housing. Lower blower assembly (rubber seal in place) into housing. Pull wiring grommet into place and
install three mounting screws.
5. Install blower motor assembly (five screws) to housing.
6. Install fresh/recirculating door into housing. Install fresh/recirculating cover (four screws). Rotate actuator shaft into door and slide actuator into
bracket and tighten two nuts.
