Caravan AWD V6-201 3.3L (1991)
Mode Door Shaft
7. To install mode door to housing, insert door shaft through housing and door pivot. Push on shaft retainer.
8. To install demister door, connect wire rod to mode door. Insert pivot end of door into hole in housing. Position opposite into slot.
9. To install heat/defrost door, insert door shaft through housing and door pivot. Push on shaft retainer.
10. Install heat distribution duct to bottom of housing with three screws.
11. To install temperature control door, install door shaft into lower pivot in the case housing. Place unit cover over housing while feeding temperature
door shaft through cover. If the temperature control door is attached to the cover, feed the door into the housing with the cover. Direct the bottom
pivot of the door with your hand through the mode door opening.
12. To install housing cover, line up cover to housing using pilot pins, the temperature door, and screw holes for alignment. Install thirteen screws.
13. Route vacuum harness through holes in cover. Install screw to retain vacuum harness. Make all vacuum hose attachments to vacuum actuators.
