Caravan AWD V6-201 3.3L (1991)
1.
Remove the fuse block access panel located on the lower instrument panel, to the left of the steering column.
2.
Locate the relay bank to the left of the fuse block panel opening.
3.
Remove the turn signal flasher (shown in location 4 of the relay bank illustration below) and replace ft with the supplied flasher.
NOTE:
Removal of the headlamp circuit breaker will provide for better access to the turn signal flasher. If removed, be sure to reinstall
the circuit breaker after replacing the flasher.
4.
Reinstall the fuse block access panel.
Completion Reporting and Reimbursement
Claims for vehicles serviced by dealers must be submitted on the DIAL System. Claims Submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Replace turn signal hasher
08315282
0.2 Hour
If a turn signal flasher was purchased for the service, add its cost plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
Parts Return
Not required, scrap the replaced flasher.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Recall Notification Form or describe the reason on a postcard and mail to: