Caravan AWD V6-201 3.3L (1991)
Electrical And Vacuum Connections To Intake Manifold
15.
Connect the PCV system, the vacuum harness to the intake plenum, the power brake booster, and the charge temperature sensor electrical
connector. Connect the EGR tube flange to the intake manifold and torque to 200 lb-in (22 Nm) (if equipped).
16.
Connect the wiring harness into the hole in the throttle cable bracket.
17.
Connect the Automatic Idle Speed (AIS) motor and Throttle Position Sensor (TPS) electrical connectors to their respective components on the
throttle body.
18.
Connect the vacuum harness to the throttle body.
19.
Install the DIS coil pack, and torque the 4 mounting bolts to 105 lb-in (12 Nm).
20.
Connect the Quick-Connect fuel fittings to the chassis tubes. Push the fittings until they make a "click" noise. Pull on the fittings to make sure
that they are securely locked into place. The fuel return fitting is 1/4 inch and the fuel supply fitting is 5/16 inch.
21.
Install throttle cable. See: Accelerator Cable/Service and Repair
22.
Install air inlet hose and air cleaner assembly.
23.
Connect negative battery cable.
24.
Pressurize fuel system and check for leaks. See: Fuel Pressure/Testing and Inspection/Fuel Pressure Leak Down Test
