Caravan AWD V6-201 3.3L (1991)
Fig. 2 Removing inner tie rod from rack
5. using a wrench to prevent rack from rotating, position a wrench on inner tie rod pivot housing flats. Turn housing counterclockwise until tie rod
assembly separates from rack.
Fig. 3 Exploded view of rack bearing
6. Loosen adjuster plug locknut then, remove adjuster plug, spring and rack bearing.
Fig. 4 Removing rack bulkhead retaining wire
7. Using a punch, rotate the right side rack bulkhead retaining wire clockwise to expose end of retaining wire. Pull retaining wire out of cylinder slot.
8. Turn stub shaft, moving rack to the right forcing the bulkhead out of the housing. Use drain pan to catch excess fluid. Remove rack.
9. Remove input shaft retaining ring, followed by pinion plug.
Fig. 5 Removing pinion locknut from pinion shaft
10. While holding stub shaft in place with holding fixture No. SP-3616, remove pinion locknut from pinion shaft. If stub shaft is not held in place
while removing locknut, damage to the pinion teeth may result.
